Filter
Top Products
8 Optical Disc Laminator Connectivity Guide
The Laminator is positioned at the front left corner of the
Duplicator. The optional Duplicator XL/Pro Laminator Stand
is needed for both of these configurations. The stand is shown
here:
STAND-ALONE MODE
The Automated Stand-Alone Mode allows you to connect the
Laminator to the Duplicator XL or DuplicatorPro without
connecting either the Duplicator or Laminator to a PC. This
mode is used when you simply want to load the Duplicator
with 100 printed discs and laminate them unattended. The
Laminator will take the place of a printer in this configuration.
Stand-Alone Mode is set up as follows:
1. Laminate a few discs in Stand-Alone configuration as
described in the Laminator User's Manual to ensure the
Laminator is configured to properly laminate your discs.
2. If present, remove the Printer Stand and Printer from the
back of the Duplicator.
3. Make sure both the Power and Auxiliary Control Cable are
connected to the Duplicator as shown:
510887.qxd 1/21/2004 7:35 PM Page 8
TOC