Filter
Top Products
Using RFID 17
Section 3: Using RFID
A: SETUP
RFID Label Stock should have an antenna imbedded between
the label adhesive layer and the liner. The antenna should be
oriented to the front of the label stock and centered within the
label.
Follow these instructions each time you load a new roll of
RFID Label Stock.
1. Load your RFID label stock according to the instructions
printed on the inside cover of your RX900 and found in
Section 2B.
2. Before you start printing, adjust the slide bar so the
Reader/Writer marker is approximately 1/8" (3mm) left or
right from center chip of the antenna. Open the cover of
the printer. You will find the slide bar and marker near the
front of the printer right behind the tear bar.
Label RFID ChipAntenna
Set Marker approxi-
mately 1/8" (3mm) left
or right from center
chip of antenna.
RFID Read/Write Marker Tear Bar Slide Bar Handle
Antenna
RX900.qxd 2/17/2011 1:28 PM Page 17
TOC
INDEX