Filter
Top Products
20 Using RFID
C. OTHER FUNCTIONS
Batch Reading Test. (Optional) After printing and encoding
labels you may run a Batch reading test to verify that each
label was encoded successfully. Simply load the printed roll,
open the status monitor and choose Batch Reading Test on the
RFID tab.
Move to next tag. Before reading, writing or calibrating, select
Move to next tag to instruct the printer to feed the label stock
to the next tag/label.
Print and encode. Use this interface to test printing and
encoding. Be sure to set your label size via the printer driver
settings accessible in printer preferences as described in
Section 5F.
(lower right on RFID tab). Click this to access and
advanced encoding interface. This interface will allow
you to communicate directly with the RFID module via text
commands. Do not use this interface unless directed to do so
by tech support.
Advanced Options. Access advanced options by clicking the
icon on the top right side of the status monitor. Click the
options button. There are
several options available. Below
are the options that concern
RFID encoding.
Print 'XXXX' on RFID Failure.
By default a series of XXXXs will
automatically be printed on the
label to indicate that it was not
encoded properly. If you disable
this option nothing will be print-
ed on an encoding failure.
Unpresent Time. This is the time
between the finish of the print
and when the printer moves the
stock back into position for the
next encoding/printing. The purpose of this setting is to allow
a specific amount of time to remove the label after a one off
print.
Unpresent Position. This is the position the label stock moves
to after the unpresent time has elapsed. This should be set to
RFID Tag when printing and encoding RFID labels.
RX900.qxd 2/17/2011 1:29 PM Page 20
TOC
INDEX