Filter
Top Products
Chapter 4 Major Cleaning
90
Cleaning The SELFOC
®
Lens
CAUTION
When wiping the SELFOC lens, do not to apply excessive
force to the drum surface potential sensor near the SELFOC
lens, as this can cause the sensor to be dislocated. (If this
happens, contact your service representative.)
24. Wipe the SELFOC lens by moving a Toraysee cloth (listed in
Table 1 on page 63) from the inner part of the printer toward
you. Wipe the lens until there is no more dirt on the cloth.
NOTE: Always wipe the SELFOC lens with the unused side of the
Toraysee.
Legend:
1) SELFOC Lens
2) Drum Surface Potential Sensor
25. Install the main charger.
26. Install the photoreceptor drum. (See page 42. )
27. Install the developing unit. (See page 42.)
28. Install the cleaning unit.
1
2