Filter
Top Products
Tsunami MP.11 Installation and Management
SOFT RESET TO FACTORY DEFAULT
If necessary, you can reset the MP.11 to the factory default settings. Resetting to default settings
means that you must configure the MP.11 anew.
To reset to factory default settings using the Web Interface:
1. Click Commands Æ Reset.
2. Click the Reset to Factory Default button.
The device configuration parameter values are reset to their factory default values.
If you do not have access to the MP.11, you can use the procedure described in “Hard Reset to
Factory Default” below as an alternative.
CLI Soft Reset to Factory Defaults
To reset to factory default settings:
set sysresettodefaults 1
HARD RESET TO FACTORY DEFAULT
If you cannot access the unit or you have lost its password, you can reset the MP.11 to the factory
default settings. Resetting to default settings means you must configure the MP.11 anew.
To reset to factory default settings, press and hold the RELOAD button on the MP.11 unit for about
10 seconds. The MP.11 reboots and restores the factory default settings.
To access the MP.11 see “Chapter 3. Management Overview” on page 17.
Chapter 7. Procedures 68
CPN 63708 Issue Date: 02/05/2003