Filter
Top Products
A–Diagnostic Utility Commands
A-2 NE0154601-00 A
-nR
--noCRegs
This command disables control register testing (use with -D or
-a).
-nF
--noFLASH
This command disables Flash testing (use with -D or -a).
-nl
--noIRQS
This command disables interrupt testing (use with -D or -a).
-nL
--noIntLB
This command disables internal loopback testing (use with -D or
-a).
-nH
--noHw
This command disables hardware testing (use with -D or -a).
-nS
--noLinkSt
This command disables link status testing (use with -D or -a).
-nl
--noLED
This command disables LED status testing (use with -D or -a).
-E
--ExtLB
This command performs an external full-duplex loopback test.
-h
--help
This command prints the help message.
-v
--version
This command displays version information.
-C
--Cmdif
This command performs an interface status test.
NOTE: This command is valid only in Linux.
Table A-1. Diagnostic Utility Commands (Continued)
Command Description