SANbox 9000
™
Series Chassis Replacement Guide
59244-00 A 3
A
Disconnect Ethernet and
Serial Cables
Disconnect Ethernet cables from CPU blades
and the Maintenance Panel.
Disconnect HyperStacking cables from the
CPU blades.
Disconnect Fibre Channel
Port Cables
Label I/O blades by slot number. I/O blade
slots are numbered IO0–IO7.
Label Fibre Channel port cables by slot
number and port number.
4-Gbps I/O blade ports are numbered
0–15 from top to bottom, left to right.
10-Gbps I/O blade ports are numbered
0–4, top to bottom, left to right.
Disconnect Fibre Channel port cables.
Remove I/O Blades
Connect an ESD wrist strap to a ground point
on the rack.
Rotate the I/O blade latch to the full open
position. Pull the I/O blade by the latch to
disengage the I/O blade from the midplane.
Carefully slide the I/O blade out of the chassis.
Remove I/O blade panels in the same way.
1. Latch, IO0 blade
IO0 IO1
0 8
7
15
1