Filter
Top Products
SANbox 9000
™
Series Chassis Replacement Guide
8 59244-00 A
Copyright© 2007 QLogic Corporation. SANbox is a trademark of QLogic Corporation
A
Observe Heartbeat LED
Observe the Heartbeat LED on the CPU
blade. It should blink once per second.
If the Heartbeat LED is showing a different
blink pattern, refer to the Installation Guide for
diagnostic procedures or contact your
authorized maintenance provider.
1. Heartbeat LED
Verify the POST Results
Open a Telnet session and enter the
Show Blade command to display the
diagnostic status for all blades. You can
also use the Switch tab and Blade Info
tab of the QuickTools interface.
telnet 10.0.0.1
Switch Login: admin
Password: password
SANbox #>show blade
Blade Blade Port Admin Oper Fault Temp Voltage
ID Type Range State State Status Status Status
----- ---- ----- ----- ----- ------ ------ ------
IO0 FC4G16 0-15 Online Online None Normal Good
IO1 FC4G16 16-31 Online Online None Normal Good
IO2 * * Online NotInst * * *
IO3 * * Online NotInst * * *
IO4 * * Online NotInst * * *
IO5 * * Online NotInst * * *
IO6 * * Online NotInst * * *
IO7 * * Online NotInst * * *
+CPU0 CPU N/A Online Online None Normal Good
CPU1 CPU N/A Online Online None Normal Good
PS0 PSFB N/A N/A N/A None N/A N/A
PS1 PSFB N/A N/A N/A None N/A N/A
FAN0 FANFB N/A N/A N/A None N/A N/A
FAN1 FANFB N/A N/A N/A None N/A N/A
MP MP N/A N/A N/A None N/A N/A
Reinstall License Keys
The old license keys are not valid with the new
chassis serial number. Visit www.QLogic.com
(Support/Product Feature Activation/
License Key Activation Center/Replace
License Keys) to obtain new license keys to
replace those installed on the original chassis.
You will need the following information:
Original chassis serial number
New chassis serial number (Show Version
command)
Your email address
With the new license keys, enter the
Feature Add command to install license keys
that were installed on the original chassis.
SANbox #> admin start
SANbox (admin) #> feature add #-XXXXXXXXXXXXX
License upgradefor HyperStack(tm) capability.
This feature upgrade does NOT require a switch reset.
Do you want to continue with license upgrade procedure?
(y/n): [n] y
Log Msg: [day mon date hh:mm:ss.sss CST year]
[C][8400.006B][Switch][Upgrading License for
HyperStack(tm)capability]
Log Msg: [day mon date hh:mm:ss.sss CST year]
[C][8400.0047][Switch][New licenses are being
installed]
1