Filter
Top Products
3 DOS / Windows 3.x Software Installation
Two DOS configuration software programs are provided with the MPAP-100: a client
driver and a card enabler. These programs are executed from DOS (before entering Windows)
and allow operation of the MPAP-100 in both the DOS and Windows 3.x environments. Table 1
highlights the differences between these programs.
Use if Card and
Socket Services
software is not
available and the
system has an Intel
82365 or compatible
socket controller.
Best for most users.
Recommendation
noyes
PCMCIA Card and Socket
Services software required
noyes
Automatic configuration of
MPAP-100 upon insertion
(Hot Swapping)
socket controller
(Intel 82365 or
compatible only)
PCMCIA card and
Socket Services
(socket-independent)
Interfaces to
DOS executableDOS device driver
File type
MPAP1EN.EXEMPAP1CL.SYS
File name
EnablerClient Driver
Table 1 --- Client driver versus enabler for DOS/Windows 3.x.
IMPORTANT
Do not use both the client driver and the enabler!
If you are unsure whether Card and Socket Services software is currently installed on
your system, install the client driver. When loaded, the client driver will display an error
message if Card and Socket Services software is not detected. If you receive such an error
message, remove the client driver software and install the enabler instead.