Filter
Top Products
5
3. Select the
TWAIN Drivers and Utility and the application
software you want to install on your system. Then click
on the
Next button to start the installation.
4. Follow the prompts to install the driver and software for
any or all of the applications listed under “Select
Components” from the CD-ROM. Follow the
instructions provided with the application software to
install it. Ô
5. After you finish installing the software, restart your
computer.
6. Plug the PC camera's USB connector into your
computer’s USB port. Ô
7. To confirm that the camera is operating properly when
you first install it, click
Start on the task bar, then click
Programs, Presto! Mr. Photo 3.2.TheMr. Photo
application 3 software runs.
8. Place the camera on a steady and level surface, and
then slowly rotate the camera so it aims at the target
image.
9. Place a light source behind the camera, facing the
subject.
!
Ó
10. Click the snapshot button on the top of the camera. The
iCam322 window opens and you see the image
captured by the camera within the iCam322 window.
11. To adjust the focus of the image you see, simply turn
the focus adjustment ring on the front of the camera in
either direction until you see the clearest image.
UNINSTALLING THE SOFTWARE DRIVER
If you need to uninstall the driver, go to and click on Control
Panel
then double click Add/Remove Programs.Selectthe
Ô NOTES Ô
• Some subsequent steps in this
section assume that you
installed the Presto! Mr. Photo
3.2 application software. If you
did not install this application
software, the screens you see
might differ from those
documented here.
• The cable fits only one way. If it
does not fit, do not force it. Turn
it over and try again.
• Refer to your computer's
owner's manual for the location
of the USB port.
Ó HINT Ó
For better images, maintain a
consistent lighting environment. Do
not mix fluorescent and other light
types.
Focus
Adjustment
Ring
25-3121.fm Page 5 Monday, April 28, 2003 2:51 PM