Filter
Top Products
4 Support
E-DOC-CTC-20031204-0011 v2.0
38
6 The Setup wizard will search for the SpeedTouch™ on the network. The following
window shows the detection progress:
7 The Setup wizard should find your SpeedTouch™ device on the local network.
This is indicated by the following window:
If more than one device is found, a list of available devices will be provided. If this
is the case, select your SpeedTouch™ device (SpeedTouch™350 or Speed-
Touch™360) and click Next.
Note If the wizard does not find any SpeedTouch™ on the network an error
window appears. In this case check that:
• The SpeedTouch™ is turned on and fully initialized.
• Your PC is correctly connected to the SpeedTouch™.
• Your PC has a valid IP address (i.e. any IP address but 0.0.0.0).
• No dedicated firewall device or router is placed between your
PC and the SpeedTouch™
• No personal firewall software is running on your PC.
• TCP/IP is correctly installed on your PC
8 To repeat the search for your SpeedTouch™, click Back and proceed with step 6
of this procedure.
9 Click Next to start the configuration procedure described below.