Filter
Top Products
M3028BT-EPB User’s Manual 2. Setup
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
2.6 Turning ON the Power
2.6.1 Checking the Connections of the Emulator System
Before turning the power ON, check the connection of the interface cable with host machine, PC7501, emulation probe, and
user system.
2.6.2 Turning ON/OFF the Power
z Turn ON the power of the emulator and user system as simultaneously as possible.
z Turn OFF the power of the emulator and user system as simultaneously as possible.
z Do not leave either the emulator or user system powered on, because of leakage current the internal circuits may be
damaged.
z When turning ON the power again after shutting OFF the power, wait for about 10 seconds.
IMPORTANT
Notes on Power Supply:
z Pin VCC is connected in order to monitor user system voltage. For this reason, the emulator cannot supply
power to the user system. Therefore, provide the user system with a separate power supply.
z The voltage of the user system should be as follows.
2.7 V ≤ VCC ≤ 5.5 V
z Do not change the voltage of the user system after turning on the power.
Page 25 of 86