Filter
Top Products
M3028BT-EPB User’s Manual 3. Usage (Emulator Debugger)
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
2. Specifying the communication interface
Specifying the communication interface
(LPT communication)
- For selecting the LPT communication, click the radio
button “LPT” of the MCU tab.
- For the Type area, specify the LPT interface
communication mode to be used. When you use the
emulator debugger for the first time, select “AUTO”.
- Specify the I/O address of the parallel port at the I/O
address area.
- For BIOS setup, the following addresses are available.
- 378h
- 278h
Specifying the communication interface
(LAN communication)
- For selecting the LAN communication, click the radio
button “LAN” of the MCU tab.
- Specify the IP address of the emulator at the IP address
area.
- Specify the IP address by one byte of decimal number
separating each four bytes with a period.
- Specify the port number at the Port area.
Note:
When you are using the LAN communication for the first
time, connect the emulator through other than LAN
communication interface and set the IP address, or use the
SETIP utility included with your product to set the IP
address.
For details about the SETIP utility, refer to the on-line
manual of your emulator debugger.
Specifying the communication interface
(USB communication)
- For selecting the USB communication, click the radio
button “USB” of the MCU tab
- The emulators connected by USB cable are shown at
Serial No. area.
- Select the serial No. of the emulator you are going to
connect.
Note:
When you are using USB communication for the first time,
you must install the USB driver first.
The USB devices are detected when you turn on the power
for the emulator, and a wizard for installing the
corresponding device driver will automatically be started.
Follow the instructions of the wizard to complete
installation.
Page 43 of 86