Filter
Top Products
M3028BT-EPB User’s Manual 2. Setup
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
2.9.3 Connecting to a 64-pin 0.5mm pitch Foot Pattern
Here following is a procedure of connecting to a 64-pin 0.5mm pitch foot pattern on the user system using the M30291T-
64FPD (included with the M3028BT-EPB-3). For details on the M30291T-64FPD, refer to its user's manual.
(1) Mount the NQPACK064SD-ND included with the M30291T-64FPD to the user system.
(2) Attach the YQPACK064SD included with the M30291T-64FPD to the NQPACK064SD-ND and secure it with the YQ-
GUIDE's.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT-EPB.
(4) Attach the M30291T-64FPD to the YQPACK064SD.
●: No. 1 pin
*: These products are included with the M30291T-64FPD package.
64-pin 0.5mm pitch
(PLQP0064KB-A) foot pattern
YQ-GUIDE (x4) *
YQPACK064SD *
NQPACK064SD-ND *
HQPACK064SD
(not included)
MCU with on-chip
flash memory etc.
(1)
(2)
(3)
(4)
M3T-FLX160-EPB
M3028BT-EPB
M30290T-PTCB *
M30291T-64FPD
Figure 2.10 Connecting to a 64-pin 0.5mm pitch foot pattern
CAUTION
Note on Connecting the User System:
z Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
targets system.
IMPORTANT
Notes on Connectors of the Converter Board:
z The connectors of the M3028BT-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
z The connectors of the M30291T-64FPD and YQPACK064SD are guaranteed for only 100 insertion/removal
iterations.
Page 33 of 86