Renesas M306N4T3-RPD-E Switch User Manual


 
( 11 / 76 )
WARNING
Warning for Installation:
Do not set this product in water or areas of high humidity. Make sure that the main unit does not
get wet. Spilling water or some other liquid into the main unit can cause an unrepairable damage.
Warnings for Use Environment:
The emulation pod is air-cooled with the ventilation slot. Therefore, do not block the ventilation
slot. When heated to high temperatures, the emulation pod may not work properly.
This equipment is to be used in an environment with a maximum ambient temperature of 35°C. Care
should be taken that this temperature is not exceeded.
CAUTION
Caution to Be Taken for Modifying This Product:
Do not disassemble or modify this product. Disassembling or modifying this product can cause
damage. Disassembling and modifying the product will void your warranty.
Cautions to Be Taken for Handling This Product:
Use caution when handling the main unit. Be careful not to apply a mechanical shock.
Do not touch the connector pins of the emulator main unit and the target MCU connector pins. Static
electricity may damage the internal circuits.
Do not pull the emulation pod main unit by the flexible cable (FLX120-RPD) for connecting to the
emulator main unit or the flexible cable (FLX64, FLX100, FLX160 or M3T-FLX160C) for
connecting the target system. The cable may cause a break.
Flexible cable (FLX120-RPD) for connecting to the emulator main unit and the flexible cable
(FLX64, FLX100, FLX160 or M3T-FLX160C) for connecting the target system are different from
earlier models. The slits make them more flexible. However, excessive flexing or force may break
conductors.
•Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
Cautions to Be Taken for Turning On the Power:
Turn on the power of the emulator and target system as simultaneously as possible.
Turn off the power of the emulator and target system as simultaneously as possible.
Do not leave either the emulator or target system powered on, because of leakage current the
internal circuits may be damaged.
When turning on the power again after shutting off the power, wait about 10 seconds.