Filter
Top Products
( 45 / 76 )
Figure 3.16 Connecting to a 100-pin 0.65-mm-pitch foot pattern (part 3)
CAUTION
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The connectors of the M30800T-PTC are guaranteed for only 50 insertion/removal
iterations.
• The connectors of the M3T-100LCC-DMS and M3T-FLX-100NRB are guaranteed
for only 20 insertion/removal iterations.
M30800T-PTC
Onboard evaluation
M3T-100LCC-DMS (not included)
M3T-FLX-100NRB (not included)
100-pin 0.65-mm-pitch (100P6S-A) foot pattern
These four parts are in one package.
These corners are not round.
CN2 side
Target system
No. 1 pin
Tip of pitch converter board
Tip of emulation pod probe
HQPACK100RB168
(not included)
Flash version MCU etc.
YQ-GUIDE's
(not included)
YQ-PACK100RB
NQPACK100RB
(5)
(6)
(4)
(3)
(2)
(1)
(4) Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 3)
Here follows how to connect the emulation pod probe to a 100-pin 0.65-mm-pitch foot pattern on the
target system with the M3T-FLX-100NRB (not included). For details on the M3T-100LCC-DMS
(not included) and M3T-FLX-100NRB (not included), refer to each user's manual.
(1) Mount the NQPACK100RB to the target system.
(2) Attach the YQPACK100RB to the NQPACK100RB and secure it with the included YQ-
GUIDE's.
(3) Attach the M3T-FLX-100NRB to the YQPACK100RB.
(4) Attach the M3T-100LCC-DMS to the M3T-FLX-100NRB.
(5) Attach the CN2 side of the M30800T-PTC to the tip (CN2 side) of the pitch converter board
connected to the emulation pod probe.
(6) Attach the M30800T-PTC to the M3T-100LCC-DMS.