( 26 / 76 )
See "4.3 Self-check" (page 51).
Within 2 seconds of turning the power ON, press the
system reset switch of the PC4701 and check it is in
maintenance mode.
Figure 2.4 Self-check procedure
Push the system reset switch of the PC4701 again to start
the self-check.
After about 40 seconds, check that the self-check is
complete normally and shut off the PC4701.
(3) Downloading Firmware
The download procedure is given in Figure 2.3. Before attempting to download the firmware, check
that the emulator is connected to the host machine.
Figure 2.3 Firmware download procedure
(4) Self-check
To confirm that your emulation pod works properly, execute the self-check after downloading the
firmware. The self-check procedure is given in Figure 2.4.
See "4.2 Downloading Firmware"
(page 50).
See "3.7 Connecting the PC4701"
(page 39).
Connect the PC4701 and this product.
Within 2 seconds of turning the power ON, press the
system reset switch of the PC4701 and check it is in
maintenance mode.
Download the firmware using the emulator debugger.
End the emulator debugger and shut the power of the
PC4701 OFF.
Set the following in the Init dialog
box when starting up the emulator
debugger.
• MCU file
• Work area, etc.