( 48 / 76 )
Chapter 4. Usage
4.1 Turning On the Power
(1) Checking Connections of the Emulator System
Before turning the power ON, check the connections of the PC4701, emulation pod, converter board
and target system.
(2) Turning On the Power
• Turn on the power of the emulator and target system as simultaneously as possible.
• Turn off the power of the emulator and target system as simultaneously as possible.
• Do not leave either the emulator or target system powered on, because of leakage current the
internal circuits may be damaged.
• When turning on the power again after shutting off the power, wait about 10 seconds.
CAUTION
Notes on Power Supply:
• Pins Vcc1 and Vcc2 of the emulator are connected to the target system to observe
the voltage of the target system. Therefore design your system so that the target
system is powered by an external power supply.
• Do not change target system power supply voltage after power has been activated.