Filter
Top Products
( 24 / 72 )
Chapter 3. Setting Up
To use this emulation probe with your target system, it is necessary to change the input frequency.
Set the input frequency after removing the upper cover.
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
(1) Remove the four screws of both sides of this product and lift off the upper cover (see Figure 3.1).
(2) Change the input frequency following the procedure.
(3) Replace the upper cover and secure the four screws.
Figure 3.1 Removing the upper cover
CAUTION
When Removing the Upper Cover:
• Always shut OFF power when removing the upper cover or changing the input
frequency.