Filter
Top Products
( 59 / 68 )
(1)When the LED Display of the PC4701 is Abnormal
Table 6.1 LED's abnormal display and checkpoints
(2)When the Init Dialog Box is Not Displayed
• Check the operation environment of the host machine where the M3T-PD38 is operating.
• The M3T-PD38 may not have been installed properly. Therefore, Reinstall it again.
Error
Connection to
the target system
Checkpoint
LEDs do not light up.
All LEDs remain lit.
The RESET LED of
"STATUS OF TARGET"
is not normal.
Others
-
-
Connected
Connected
Recheck the power cable is connected to the PC4701.
See the user's manual of the PC4701.
Recheck the connection between the PC4701 and this
product.
See "3.6 Connecting the PC4701 and Emulation Pod"
(page 34).
Check the oscillator circuit in the emulation pod has been
installed correctly.
The CLOCK LED of
"STATUS OF TARGET"
does not light up.
The POWER LED of
"STATUS OF TARGET"
does not light up.
Check power is properly supplied to the target system.
-
-
Check the rest pin of the target system does not remain
'L' level. The display of the RESET LED differs depending
on version of the M3T-PD38.
See "4.1 (3) LED Display When the PC4701 Starts Up
Normally" (page 39).
The firmware version may be different. Download
firmware in maintenance mode.
See "4.2 (2) Downloading Firmware in Maintenance
Mode" (page 40).