Filter
Top Products
( 18 / 52 )
2.5 When Using the Emulator for the First Time
If you have purchased this emulation pod newly, it is necessary to download the firmware. The
download procedure is given in Figure 2.3.
Before attempting to download the firmware, check the emulator debugger is installed and the pod
probe, the PC4701 and the host machine are connected. For more information, see each user's manual
of the emulator debugger and the PC4701.
Figure 2.3 Firmware download procedure when emulator is used for the first time
To make sure the emulation pod works properly, run the self-check. For self-check procedures, see
"4.4 Self-check" (page 34).
Shut power OFF.
Connect the PC4701 and this product.
Within 2 seconds of turning the power ON, press the
RESET switch of the PC4701 and check maintenance
mode is accessed.
Download the firmware using the emulator debugger.
See "4.2 Downloading Firmware"
(page 32).
See "3.3 Connecting the PC4701
and Emulation Pod" (page 26).
Connect the pod probe and this product.
See "3.2 Connecting the Pod Probe
and Emulation Pod" (page 24).