Filter
Top Products
( 25 / 52 )
With the 7900 Series emulator system, the internal flash ROM of the emulator MCU is used as an
emulation memory.
As write/erase iterations to the internal ROM are limited, it is necessary to replace the MCU board
(M379xxTx-PRBM) depending on its life span.
How to replace the MCU board is shown in Figure 3.8.
Figure 3.8 Removing MCU board M379xxTx-PRBM
(1) Unscrew the 4 screws of the M379xxTx-PRB.
(2) Remove the M379xxTx-PRBM from the M379xxTx-
PRB. In this time, lift off the M379xxTx-PRBM
horizontally. Otherwise, the connector may cause a
break.
CAUTION
When Connecting Pod Probe:
• Always shut OFF power when connecting the pod probe. The power ON state could
destroy internal circuits.
• The insertion/removal iterations of the connector of the pod probe are limited. Check
your pod probe's user's manual.
• For some types of the pod probe, the method of connection is different. Check your
pod probe's user's manual.