Filter
Top Products
25
Usage Example of Sequential Break Extension Setting: A tutorial program provided for the
product is used as an example. For the tutorial program, refer to section 6, Tutorial, in the
SuperH
TM
Family E10A-USB Emulator User’s Manual.
The conditions of Event Condition are set as follows:
1. Ch3
Breaks address H’00001068 when the condition [Only program fetched address after] is
satisfied.
2. Ch2
Breaks address H’0000107a when the condition [Only program fetched address after] is
satisfied.
3. Ch1
Breaks address H’00001086 when the condition [Only program fetched address after] is
satisfied.
Note: Do not set other channels.
4. Sets the content of the [Ch1,2,3] list box to [Break: Ch 3-2-1] in the [Combination action
(Sequential or PtoP)] dialog box.
5. Enables the condition of Event Condition 1 from the popup menu by clicking the right mouse
button on the [Event Condition] sheet.
Then, set the program counter and stack pointer (PC = H’00000800, R15 = H’00010000) in the
[Registers] window and click the [Go] button. If this does not execute normally, issue a reset and
execute the above procedures.
The program is executed up to the condition of Ch1 and halted. Here, the condition is satisfied in
the order of Ch3 -> 2 -> 1.