Filter
Top Products
Setting Up the Software
3.2.2 Setting Up the E10A-USB Emulator
Rev. 1.01 May 7, 2008
3-15
REJ11J0015-0101
3
(3) Search the CD-ROM for drivers and select” <drive>:¥driver¥usb¥xp¥elusb.inf“ and then click “Next”. The ‘xp’ in the
underlined part (in the setup here, Windows XP) indicates the OS version.
Figure3.2.19 New Hardware Detection Wizard Start (3)
Note: If [Hardware installation] dialog box, which says the software has not passed Windows Logo.. is displayed, just
click “Continue Anyway”. The version numbers differ with each device group supported by the E10A-USB
emulator.
(4) [Found New Hardware Wizard] dialog box shown below will be displayed. Click “Finish”. You’ve now finished setting
up the E10A-USB emulator driver.
Figure3.2.20 Finish New Hardware Detection Wizard Dialog Box