Filter
Top Products
Running the Software
4.1.3 E10A-USB Emulator Connection Error Dialog
Rev. 1.01 May 7, 2008
4-6
REJ11J0015-0101
4
4.1.3 E10A-USB Emulator Connection Error Dialog
If the E10A-USB emulator does not start up, the dialog box shown below will be displayed.
(a) If the dialog box shown below is displayed and the E10A-USB emulator cannot be started by the method in (11) on the
previous page, the SH7670 CPU board may not be supplied with the system power. Check the power supply for the
SH7670 CPU board.
Figure 4.1.9 Can not find /RESET signal Dialog Box
(b) If the dialog box shown below is displayed, the H-UDI pins and the H-UDI port connector may not be connected
correctly. Check the connection between the H-UDI pins and the H-UDI port connector.
Figure 4.1.10 Check the Connection Dialog Box
(c) If the dialog box shown below is displayed, the E10A-USB emulator firmware may not be set up correctly. Use the
setup tool or the additional license tool to set up the firmware for the device group that you use.
Figure 4.1.11 Product Currently Connected Dialog Box
(d) If the dialog box shown below is displayed, the firmware version set up in the E10A-USB may be old. Use the setup tool
to set up the appropriate version of firmware.
Figure 4.1.12 Version of the Emulator Firmware Dialog Box