Filter
Top Products
Environmental conditions greatly affect the performance of a copier. Be
sure to choose your installation location carefully.
Optimum Setting Conditions
Temperature: 10
-
35°C (50
-
95°F)
Humidity: 15
-
80% RH
Place upon a strong, stable, level
base with a flat, even surface. Do
not place on a surface that has
holes, ruts, cavities or is uneven
in any way.
The copier must be level within
3mm (0.11 in.) both front to rear
and left to right.
To avoid a possible ozone
buildup, be sure to locate this
copier in a large well ventilated
room with an air turnover of
more than 3 times/hr/person.
Locations to Avoid
Locations exposed to direct
sunlight or strong light (more
than 2,000 lux).
Locations directly exposed to
cool air from an air conditioner
or heated air from a heater.
(Sudden temperature changes
may cause condensation within
the copier.)
Places where the copier might be
subjected to frequent strong
vibration.
Dusty areas.
Areas exposed to corrosive
gases.
Places higher than
2,000m
(6,500
ft.) above sea level.
Copier Location
Place the copier near the wall outlet, providing minimum clearance as
shown.
More than 20cm (7.9 in.)
More than
10cm
(3.9 in.)
+
l
More than 11 cm
More than 30cm (11.8 in.)
22
FT1008/1208
f
El-B
619
22-23