Ricoh 1075 All in One Printer User Manual


 
User Tools (System Settings)
86
5
Interface Settings/Parallel Interface
Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circum-
stances, you will not need to change this setting.
Note
Default setting: ACK outside
Parallel Communication Speed
Specifies the communication speed of the parallel interface. If the communi-
cation speed is set too fast, data transfer may not flow smoothly. If this occurs,
change the setting to Standard.
Note
Default setting: High speed
Selection Signal Status
Specifies the signal setting of the parallel interface.
Note
Default setting: High
Input Prime
Specifies whether the prime signal is active or inactive when an input prime
signal is sent. Under normal circumstances, you will not need to change this
setting.
Note
Default setting: Invalid
Bidirectional Communication
Specifies the printer's response mode and so forth for a status request when
using the parallel interface. If you experience problems when using other
manufacturers, printers, set this to OFF.
Limitation
If this is set to OFF, bidirectional communication functions will not
work.
Note
Default setting: ON
Signal Control
Specifies the error processing settings for when an error occurs when printing
from a computer. Under normal circumstances, you will not need to change
this setting.
Note
Default setting: Job acceptance priority
MartiniC1_GBzen2_FM.book Page 86 Friday, April 19, 2002 2:18 PM