Ricoh 1350 All in One Printer User Manual


 
Installing the Printer Driver Using IEEE 1394 (SCSI print)
45
1
F Follow the on-screen instructions.
If the printer driver has already been installed, the printer icon is added to the
[Printers and Faxes] window. In this case, printer driver installation is not nec-
essary.
Even if the printer driver is already installed, the message “Found New Hard-
ware Wizard” may appear when the machine is connected to the computer
using the IEEE 1394 interface cable for the first time. In that case, install the
printer driver.
Note
This machine can receive print data from one computer at a time only. If a
print job from a computer collides with other data, a message may appear
on the computer.
To install another printer driver after setting the “1394_00n” port, click
[1394_00] as a port during the printer driver installation.
When the printer driver is properly installed, connecting or disconnecting
the optional IEEE 1394 cable causes the printer icon to change.
If printing does not work properly after the installation, delete the port and
reinstall the printer driver. For details, see Trouble Shooting.
If you do not want to install the printer when Found New Hardware Wiz-
ard starts under an operating system that supports SCSI print, disable the
device by following the procedure below:
A When the [Found New Hardware Wizard] dialog box appears, check that
[This wizard helps you install software for: Unknown] is displayed, select the
[Install from a list on specific location (Advanced)] check box, and then click
[Next >].
B When the message “Please choose your search and installation option.”
appears, clear all check boxes from [Search for the best driver in these loca-
tions.], and then click [Next >].
C When the message “The wizard could not find the software on your
computer for..” appears, click [OK].
D When the message “Cannot Install this Hardware” appears, select the
[Don't prompt again to install the software] check box, and then click [Finish].