Filter
Top Products
Troubleshooting When Using the Facsimile Function
22
3
When a Message Is Displayed
This section describes the machine's main messages. If other messages appear,
follow their instructions.
Message Cause Solution
Error occurred,
and trans. was
cancelled.
A document jam occurred during
Immediate Transmission. There
may be a problem with the ma-
chine or the telephone line (for ex-
ample, noise or cross talk).
Press [Exit], and then resend the
pages that have not been sent.
If the error reoccurs frequently,
contact your service representative.
Put original
back, check it
and press Start
key.
Original jammed during Memory
Transmission.
Place originals that have not been
scanned on the exposure glass,
ADF or ARDF again.
Cannot detect
original size.
Place original
again, then
press Start key.
The machine failed to detect the
size of the original.
Place original again, and then
press the {Start} key.
LFunc. Problems
Data will be
initialized.
There is a problem with the fax. Record the code number shown
in the display and contact your
service representative.
Other functions can be used.
Memory is full.
Scanning will be
stopped and only
scanned page(s)
will be stored.
The memory is full. If you press [Exit], the machine re-
turns to standby mode and starts
transmitting the pages that have
been stored.
Cannot send fax
as scanner is in
use by another
function.
The machine is scanning an origi-
nal under another function.
Before sending the fax, cancel the
current scan job under the other
function. To do this, press the
{Clear/Stop} key on the control
panel to display the message
“
Clear/Stop key was
pressed. Stop scan-
ning?
”, and then press [Stop].
Updating the
settings... Re-
select
dest./func-
tions after up-
date finishes.
The destination list is being up-
dated from the network using
SmartDeviceMonitor for Admin
or Web Image Monitor.
Wait until the message disap-
pears. Do not switch off the pow-
er while this message is
displayed.