Filter
Top Products
Troubleshooting
88
4
In Margin Adjustment
mode, parts of the original
image are not copied.
You set a wide erased mar-
gin.
Set a narrower margin with the User
Tools. ⇒ p.103 “Front Margin:
Left/Right”, ⇒ p.103 “Front Mar-
gin: Top/Bottom”, ⇒ p.103 “Back
Margin: Left/Right”, ⇒ p.103 “Back
Margin: Top/Bottom”
There is a lack of margin
space on the opposite side
of the binding position.
In Image Repeat mode, the
original image is not cop-
ied repeatedly.
You selected copy paper
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
Select copy paper larger than the
originals.
Select the proper reproduction ratio.
The stamp position is
wrong.
The paper orientation is
wrong.
Check the paper orientation and
stamp position.
When Combine, parts of
the image are not copied.
You specified a reproduc-
tion ratio that does not
match the sizes of your
originals and copy paper.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the copy
paper.
Note
❒ Select the correct reproduction
ratio before using Combine
mode.
Order of copies is not cor-
rect.
You placed the originals in
the incorrect order.
When placing a stack of originals in
the document feeder, the last page
should be on the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
When Duplex, copy is
made Top/Bottom even
though Left/Right is se-
lected, or copy is made
Left/Right even though
Top/Bottom is selected.
You placed the originals in
the wrong direction.
Place the originals in the correct ori-
entation. ⇒ p.10 “Original Orienta-
tion”
Paper does not output dur-
ing printing with stapling.
When you stop printing
while using the staple func-
tion, papers not stapled
during printing may be left
in the staple unit.
Press the
{
{{
{
Reset
}
}}
}
key and cancel
copy settings, including stapling.
Problem Cause Action