Filter
Top Products
PPC-154 User’s Manual 14
2.2 Preparing for First-time Use
Before you start to set up the panel PC system, you should have at least
the following items ready:
• Power cord (in the accessory box)
• Keyboard
• Mouse (for system software installation)
2.3 Installation Procedures
2.3.1 Connecting the power cord
The panel PC can only be powered through an AC electrical outlet (100 ~
240 volts, 50 ~ 60 Hz). Be sure to always handle the power cords by hold-
ing the plug ends only.
Follow these procedures in order:
1. Connect the female end of the power cord to the AC inlet of the
panel PC.
2. Connect the 3-pin male plug of the power cord to an electrical out-
let.
2.3.2 Connecting the keyboard and mouse
Connect the PS/2 mouse and keyboard to the I/O section of PPC
If you use a serial mouse and your panel PC has a touchscreen, you can
connect the mouse to any COM port except COM4.
2.3.3 Switching on the power
Switch on the power switch on the rear cover.