Filter
Top Products
43 Chapter 5
5.4 COM-port interface (JP4, JP5)
The panel PC provides two serial ports. COM1 (RS-232) and COM2 (RS-
232/422/485) in one COM port connector.
5.4.1 COM2 RS-232/422/485 setting (JP4)
COM2 can be configured to operate in RS-232, RS-422, or RS-485 mode.
This is done via JP6.
The IRQ and the address ranges for COM 1 and 2 are fixed. However, if
you wish to disable the port or change these parameters later you can do
this in the system BIOS setup. The table overleaf shows the default set-
tings for the panel PC’s serial ports.
Table 5.5: COM2 RS-232/422/485 setting (JP4)
*RS-232
RS-422
RS-485
* default setting
13579131517 11
246810141618 12
97
8
531
6421012
1115 13
141618
17
13579131517 11
246810141618 12
97
8
531
6421012
1115 13
141618
17
97
8
531
6421012
1115 13
141618
17