Filter
Top Products
Operate the Everest printer
110632_L 7
- driver was previously installed, remove
- To install the Everest printer driver on the PC, you must have administrative
isc drive.
er Setup.exe file.
4. Follow the prompts to complete the installation.
Operate the Everest printer
This section provides the information needed to use your Everest printer.
Powering on and off the Everest printer
The Everest printer does not have a power switch:
Note: The printer will go into sleep mode if it is idle for more than 30 minutes. When this
occurs, the printer will take 2-3 minutes to warm up after a job is sent to the printer.
• If the Everest printer is on an autoloader, the printer is powered on when the autoloader is
powered on. To power off the Everest printer, power off the autoloader.
• If the Everest printer is a standalone printer, connect the power cord from the Everest printer
to a power outlet to power on the printer. To power off the Everest printer, disconnect the
power cord.
Installing the Everest printer driver
Before printing, you must install the printer driver. If your Rimage Everest printer was included
with an autoloader that has an embedded PC or a control center, the Everest printer driver
is already installed.
Before you begin:
1. Connect the USB cable.
2. Connect the power cord.
3. Ensure that the Everest printer is powered on.
Note: If the Everest printer is a standalone printer (not on an autoloader), the Everest
printer will power on when you connect the power cord. If the Everest printer is on an
autoloader, the Everest printer will power on when you power on the autoloader. For
more information, refer to ‘Powering on and off the Everest printer’ on page
7.
4. If the Found New Hardware Wizard opens, select Cancel.
5. On the computer, close all applications.
Installing the Everest printer driver on Windows
Important: If an older version of the Everest printer
the previous version before installing the new one.
Important!
privileges.
1. Place the software CD in the PC d
2. Navigate: Start > Run > Browse.
3. From the software CD, select the Everest printer driv