RoboteQ AX1500 Computer Hardware User Manual


 
Using the Roborun Configuration Utility
162 AX1500 Motor Controller Users Manual Version 1.9b. June 1, 2007
after the installation is complete, run the program from your Start Menu > Programs
> Roboteq
The controller does not need to be connected to the PC to start the Utility.
Connecting the Controller to the PC
The controller must be connected to the PC to use the Utility to perform any of the follow-
ing functions:
to read the current parameters stored in the controller and display them on the
computer
to store new parameters in the controller
to exercise the motors using your PC
to update the controllers software
calibrate the Amps sensor
If the controller is not connected, the Configuration Utility can run and be used to automat-
ically generate the setting codes for manual entry. See Encoder Setting and Testing on
page 168.
Most computers have at least one, but often times two, serial ports. Look for one or two
connectors resembling the illustration in Figure 87.
If a serial port connector is already connected to something else, it may be possible to
unplug the current device and temporarily connect the controller as long as the software
operating the current device is not running. If no serial port is available on your PC, use an
USB to RS232 adapter.
Connect the provided serial cable to the controller on one end and to the PC on the other.
Power the controller, preferably using the Power Control terminal, with a 12 to 40V battery
or power supply with 200mA of minimum output.
Connect the Controllers Ground to the negative (-) terminal, and the Power Control input to
the positive (+) of the power supply. The controller will turn On. If it doesnt, verify that the
polarity is not reversed. Leave VMot unconnected unless you want to exercise the Motors.
FIGURE 87. Look for a 9-pin male connector on your PC