Filter
Top Products
10
5 Basic Operation
5-7 Pausing Operations
If you want to stop the PNC-5000 momentarily while it is printing or cutting, follow the procedure described below.
1) Halt transmission of printing or cutting instructions
from the computer.
2) Press the SETUP key.
1 2
Press the PAUSE key.
Printing or cutting is paused.
The PAUSE LED
lights up
To resume printing or cutting
Press the PAUSE key.
To Terminate printing or cutting
Printing or cutting is resumes.
The PAUSE LED
goes out
Printing or cutting instructions already sent
from the computer to the PNC-5000 are
deleted, and operation stops.
1
Switch off the power,
and set DIP switch
SW-9 to ON.
5
7
Switch on the power, load the
alignment tool, ribbon
cartridge, and material, then
press the SETUP key.
(The alignment tool is installed
on the cutting carriage in the
same way as a blade holder.)
Rear
Front
Send the printing data from
the computer.
Before data output begins, two crop
marks are automatically printed on the
left and right areas at the front edge of
the material.
Rear
Front
The ALIGN POINT SET LED lights up The BASE POINT SET LED lights up
2) Set the align point
Use the cursor keys to
move the tip of the
alignment tool to the
square crop mark at the
lower left area of the
material, then press the
ALIGN POINT SET key.
1) Set the base point
Use the cursor keys to
move the tip of the
alignment tool to the
square crop mark at the
lower right area of the
material, then press the
BASE POINT SET key.
Send the cutting data from the computer.
1)2)
The SETUP LED goes out
2
3
When printing is finished press the SETUP key, remove the material and carry
out lamination (or whatever further processing needs to be done).
When done, reload the material in the same position used for printing, and press
the SETUP key. (The SETUP LED goes out.)
4
6
Remove the alignment tool from the cutting carriage and install a blade.
5-8 Removing and Reloading Printed Material for Cutting
NOTICE
When reloading material, be sure to make the settings described above. Crop marks or other marks that have been set with
application software cannot be used.