Filter
Top Products
ULTRA ATA/133 PCI RAID Card RC200 User Manual
10
5. Assign Source drive, then assign Destination drive.
6. Press Y to copy from Source to Destination drive.
7. Press N to Offline copy.
8. Answer Y to enable Auto-Rebuild.
9. When asked Are You Sure?, press Y to accept.
10. Press ESC to exit the RAID BIOS.
For Auto Setup
＊
Use this setup on New/Blank hard drives only.
1. As the BIOS boots press F3 when prompted to enter the RAID BIOS.
2. Press F2 to create a RAID Set.
3. Press F2 to create Mirror Set.
4. Press Y to use Auto Setup.
5. Press Y to accept the configuration.
6. Configure another RAID set or press ESC to reboot.
7. Continue with FDISK and FORMAT steps as if you were installing a conventional hard
drive.
Creating a SPARE Drive
When a hard drive failure occurs in a mirror set, the auto-rebuild feature enables a drive
designated as SPARE to become the new member of the mirror set.
1. As the BIOS boots press F3 when prompted to enter the RAID BIOS.
2. Press F3 to create a spare drive.
3. Enter the drive number of the hard drive.