Filter
Top Products
ULTRA ATA/133 PCI RAID Card RC200 User Manual
24
8. Click Next again, then Finish.
9. Restart Windows to complete driver installation.
＊
To Verify Windows® 98SE/ME Installation
1. Right-click My Computer, then click Properties, Select Device Manager tab.
2. Double click SCSI Controllers, Silicon Image SiI 0680 ultra-133 Medley ATA Raid
Controller should be listed.
3. Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and click
Properties. A message this device is working properly is displayed in the dialog box, the
driver has been correctly installed. If any error message is displayed, remove Silicon
Image SiI 0680 ultra-133 Medley ATA Raid Controller and restart your system.
For Windows® NT 4.0
＊
For New Windows® NT 4.0 Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk,
copy the contents of the “RC-200\raid” folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Setup the RAID Array prior to Windows® NT 4.0 installation.
2. Install the board and follow Microsoft procedures to install Windows NT 4.0
accordingly.
3. At the Windows NT Setup screen, press F6 to specify and add the driver.
4. Press S, select Other, then press Enter.
5. Insert the driver diskette and press Enter.
6. Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and press Enter.