Filter
Top Products
ULTRA ATA/133 PCI RAID Card RC200 User Manual
27
For Windows® XP/Server 2003
＊
For New Windows® XP/Server 2003 Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk,
copy the contents of the “RC-200\raid” folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Install the board and follow Microsoft procedures to install Windows ®XP/Server 2003
accordingly.
3. Restart your system when prompted during Windows’ installation.
4. At the Windows XP/Server 2003 screen, press F6 to install the driver.
5. Insert the driver diskette. Press S, then press Enter.
6. Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and press Enter.
7. Press Enter to continue and follow on-screen instructions to complete installation.
8. When the Software Installation warning pops up. Click Yes. And when the Hardware
Installation warning pops up, click Yes again.
＊
For Existing Windows® XP/Server 2003 Installation
1. Setup the RAID Array prior to driver installation.
2. Install the board and boot up Windows.
3. At the Found New Hardware Wizard, click Next.
4. Choose “Install from a list or specific location(Advanced), and then click Next to
continue.
5. Choose Search for the best driver in these location and check the option Include this
location in the search.