Filter
Top Products
ULTRA ATA/133 PCI RAID Card RC200 User Manual
25
7. Press Enter to continue and follow on-screen instructions to complete Windows NT 4.0
installation.
＊
For Existing Windows® NT 4.0 Installation
1. Setup the RAID Array prior to driver installation.
2. Install the board and boot up Windows® NT 4.0
3. Double click My Computer/Control Panel/SCSI Adapters, then click Drivers tab.
4. Click Add… then Have Disk…
5. Insert the driver CD, type D:\RC-200\raid (Note: “D:\” represents the drive letter
assigned to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive,
substitute D with the correct drive letter), then click OK
6. Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and click OK.
7. Click OK, restart Windows NT 4.0 to complete driver installation.
＊
To Verify Windows® NT 4.0 Installation
1. Double click My Computer/Control Panel/SCSI Adapters.
2. Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller from SCSI
Adapters listing and click Properties. A message this device is working properly is
displayed in the dialog box, the driver has been correctly installed.
For Windows® 2000
＊
For New Windows® 2000 Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk,