Filter
Top Products
Installation
14 Runco CL-810 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the CL-810 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
If installing a CL-810 Ultra/CineWide with AutoScope:
Install AutoScope lens motor (optional)
22
3
Mount the projector 25
4
If installing with an SDC-1, connect ONLY the SDC-1
output to the CL-810 and make all other connections to the
SDC-1; continue with Step 7
-- OR --
If installing without an SDC-1, connect signal sources to
the CL-810 and continue with Step 5
27
5
Connect external controller to RS-232 port (optional) 30
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional)
31
7
Apply power to the projector 32
8
Change the OSD Language (optional) 33
9
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
33
10
Primary lens adjustments: projected image size (zoom),
position (shift) and focus
18, 33
11
Install CineWide anamorphic lens (optional) 34
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus
36
13
Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
53 through 59
Note