Filter
Top Products
IMPORTANT INFORMATION
3
» Precautions
Please read this manual carefully before using your plasma monitor and keep the manual handy for future reference.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
ALSO DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR
OTHER OUTLETS, UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING
THE CABINET AS THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
» Warnings and Safety Precautions
No maintenance other than cleaning is required. Please see the section “Plasma monitor cleaning procedure” on page 4.
The plasma display panel consists of fine picture elements (cells). There may be some cells that do not produce
light or remain lit. For operating safety and to avoid damage to the unit, read carefully and observe the following
instructions. To avoid shock and fire hazards:
1. Provide adequate space for ventilation to avoid internal heat build-up. Do not cover rear vents or install the unit
in a closed cabinet or shelves. If you install the unit in an enclosure, make sure there is adequate space at the top of
the unit to allow hot air to rise and escape. If the monitor becomes too hot, the overheat protector will be activated
and the monitor will be turned off. If this happens, turn off the power to the monitor and unplug the power cord.
If the room where the monitor is installed is particularly hot, move the monitor to a cooler location, and wait for
60 minutes to cool the monitor. If the problem persists, contact your dealer for service.
2. Do not use this unit’s polarized plug with extension cords or outlets unless the prongs can be completely
inserted.
3. Do not expose the unit to water or moisture.
4. Avoid damage to the power cord, and do not attempt to modify the power cord.
5. Unplug the power cord during electrical storms or if the unit will not be used over a long period.
6. Do not open the cabinet which has potentially dangerous high voltage components inside. If the unit is damaged
in this way the warranty will be void. Moreover, there is a serious risk of electric shock.
7. Do not attempt to service or repair the unit. The manufacturer is not liable for any bodily harm or damage caused
if unqualified persons attempt service or open the back cover. Refer all service to authorized Service Centers.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude, it is dangerous
to make any kind of contact with any part inside this unit. This symbol alerts the user that important literature
concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully
in order to avoid any problems.
!