Filter
Top Products
Enabling/disabling remote control wireless transmission
This function enables/disables remote control wireless transmission.
Example: Setting “OFF”
Perform the following operations.
Press the MENU button on the remote control to display the MAIN MENU on the screen, then...
1. Use the
and buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen
appears.
2. Use the and buttons to select “IR ENABLE”.
3. To set the IR ENABLE to “OFF”...
Use the and buttons to select “OFF”, then press the MENU button.
The mode switches as follows each time the or button is pressed: OFF ON
4. Once the setting is completed ...
Press the EXIT button to return to the main menu.
To delete the main menu, press the EXIT button once more.
50
OSD (On Screen Display) Controls
TIMER
INPUT SELECT : LAST
CONTROL LOCK : OFF
IR ENABLE : ON
LOOP OUT : OFF
ID NUMBER : ALL
VIDEO WALL
INSTALL 3 3 / 3
PREVIOUS PG
SEL. ADJ. RETURN
EXIT
Information
■ IR ENABLE settings
ON ........ Enables remote control wireless transmission.
OFF ....... Disables remote control wireless transmission.
Set “OFF” to avoid unwanted control from other remote
controls.
■ Restoring the factory default settings
Select “FACTORY” under the INSTALL 1 menu.
Note that this also restores other settings to the factory
defaults.
Loop Out Setting
When this feature is set to ON, the received signal will be looped out. Example: Setting “ON”
Perform the following operations. Press the MENU button on the remote control to display the MAIN MENU on
the screen, then...
1. Use the
and buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen
appears.
2. Use the and buttons to select “LOOP OUT”.
3. To set the LOOP OUT to “ON”... Use the and buttons to select “ON”.
The mode switches as follows each time the or button is pressed: OFF ON
TIMER
INPUT SELECT : LAST
CONTROL LOCK : OFF
IR ENABLE : ON
LOOP OUT : OFF
ID NUMBER : ALL
VIDEO WALL
INSTALL 3 3 / 3
PREVIOUS PG
SEL. ADJ. RETURN
EXIT
Information
■ LOOP OUT settings
ON ........ The received signal will be looped out via PC1 terminal or VIDEO1 terminal.
OFF ....... The received signal will not loop out.
* Even if LOOP OUT is ON, signals would not be sent out if POWER is being turned off.
■ To connect to another display, refer to Loop Out Setting
■ If the RGB/PC1 signal is present at the time the power is switched on...
The RGB/PC1 input will be displayed regardless of the setting of LOOP OUT.
■ Restoring the factory default settings
Select “FACTORY” under the INSTALL 1 menu. Note that this also restores other settings to the factory defaults.