Filter
Top Products
3-4
Connections
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
56
34
12
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
FROM LOCAL KEYPAD
Interface or VGA - RGB Cable
RS232 IN RS232 OUT IR COMM PORT REMOTE R G(s) B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
SOURCE SELECTION
SELECT AN INPUT
FROM BELOW:
RGB
S-VIDEO
VIDEO
COMPONENT VIDEO
Select with
or
then <ENTER>
<EXIT> to return
FROM RCU
VCR HDTV player
RS232 IN RS232 OUT IR COMM PORT REMOTE R G(s) B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
56
34
12
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
FROM LOCAL KEYPAD
Connecting a RGB Analog source.
RGB analog input terminals with composite or separate sync, or with
sync on green. The projector detects automatically where the sync sig-
nal is located.
Always use an interface when a computer and local monitor have to be
connected to the projector. Examples of interfaces which can be
applied :
RGBS or RGsB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’ in chap-
ter “Location and function of controls’.)
-Press ADJUST key, the General access menu is displayed on
the screen.
-Use the control disk to highlight 3.
-Press ENTER to select the highlighted source.
Connecting a RGB Analog source with Tri-level sync.
RGB analog input terminals with Tri level sync input or with
Tri-level sync on green. The projector detects automatically
where the sync signal is located.
RGB3S or RG3sB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’ in
chapter ‘Location and function of controls’.)
-Press ADJUST key, the General access menu is dis-
played on the screen.
-Use the control disk to highlight 4.
-Press ENTER to select the highlighted source.