Filter
Top Products
6-4
Random Access Adjustment Mode
Peaking
Peaking improves the contours in a projected image. Highlight PEAKING by push-
ing the control disc up or down and press ENTER to toggle the peaking between
OFF and ON. During the creation of new settings for a RGB source the peaking is
switched to OFF.
Line Doubler
This will turn the internal processor (which is actually a scaler with a 540p/33.8
Khz output) on or off. Typically, this should be left on; it will turn itself ‘off’ when
a DTV or computer signal is input. When it is off, the image will run at a standard
NTSC scan rate, which is 15.75 Khz.
Color Select
Highlight COLOR SELECT by pushing the control disc up or down and press
ENTER to display the color select menu.
Use the control disc to highlight a color (CRT) or combination of colors to display
the projected image in that specific color.
To select a new color, press ENTER, the color selection menu appears.
ENTER continues to the color select menu.
EXIT will return to Internal Crosshatch Selection or Setup
Pattern Selection Menu.
ADJUST returns to operational mode.
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PEAKING :
LINE DOUBLER : ON
Select with
<ENTER> to accept
<EXIT> to return.
or
OFF
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
GEOMETRY
CONVERGENCE
Select with
<ENTER> to accept
<EXIT> to return.
or
COLOR SELECT
COLOR SELECT
RED
GREEN
BLUE
RED AND GREEN
BLUE AND GREEN
RED AND BLUE
Select with
<ENTER> to accept
<EXIT> to return.
or
ENTER continues to the color select menu.
EXIT will return to Internal Crosshatch Selection or Setup
Pattern Selection Menu.
ADJUST returns to operational mode.