Filter
Top Products
3-4
Connections
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
56
34
12
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
FROM LOCAL KEYPAD
RS232 IN RS232 OUT IR COMM PORT REMOTE R G(s) B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
12v Fuse
Mask Screen
SOURCE SELECTION
SELECT AN INPUT
FROM BELOW:
RGB
S-VIDEO
VIDEO
COMPONENT VIDEO
Select with
or
then <ENTER>
<EXIT> to return
FROM RCU
VCR HDTV player
RS232 IN RS232 OUT IR COMM PORT REMOTE R G(s) B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
12v Fuse
Mask Screen
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
56
34
12
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
FROM LOCAL KEYPAD
Connecting a RGB Analog source.
RGB analog input terminals with composite or separate sync, or with
sync on green. The projector detects automatically where the sync sig-
nal is located.
This is where the output of the controller is connected to.
RGBS or RGsB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’ in chap-
ter “Location and function of controls’.)
-Press ADJUST key, the General access menu is displayed on
the screen.
-Use the control disk to highlight 3.
-Press ENTER to select the highlighted source.
Connecting a RGB Analog source with Tri-level sync.
RGB analog input terminals with Tri level sync input or with
Tri-level sync on green. The projector detects automatically
where the sync signal is located.
RGB3S or RG3sB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’ in
chapter ‘Location and function of controls’.)
-Press ADJUST key, the General access menu is dis-
played on the screen.
-Use the control disk to highlight 4.
-Press ENTER to select the highlighted source.