Filter
Top Products
Installation
26 Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual
PRE
L
IMINAR
Y
3.5
Installing the Optional
CineWide Lens Mount
If you are installing a VX-40d/-50d/-60d/-80d with the optional CineWide or CineWide with
AutoScope system, proceed as follows to install the anamorphic lens mounting assembly
(stationary base plate or AutoScope lens motor).
Remove Projector Front
Feet (CineWide with
AutoScope)
(Skip this step if you are installing a fixed CineWide anamorphic lens.)
Place the projector upside down on a blanket or other soft surface. Loosen and remove
the two front feet on the projector.
Install Anamorphic Lens
Motor (CineWide with
AutoScope) or Base Plate
(fixed CineWide)
CineWide with AutoScope: Line up the
eight mounting holes on the lens motor
housing with those on the bottom of the
projector.
Secure the motor to the projector with the
eight screws provided for this purpose.
Fixed CineWide: Line up the seven
mounting holes on the lens mount base plate
with those on the bottom of the projector,
directly below the primary lens. Secure the
base plate to the projector with the screws
provided for this purpose.
1. Do not install the CineWide lens yet, only the mounting plate or
lens motor. You will install the CineWide lens after you install the
projector and adjust the primary lens.
2. Some of the following steps are necessary only for CineWide
with AutoScope installations.
Note
➤
➤
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies
are both fully assembled.
Note