Filter
Top Products
Installation
Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual 47
PRE
L
IMINAR
Y
Auto SetupUse the Auto Setup feature of the VX-40d/-50d/-60d/-80d as a convenient starting point
for calibrating the projector inputs for optimum picture quality.
Auto Setup is an automated process in which the projector quickly optimizes critical
display parameters such as size, position and pixel tracking, based on the type of
incoming video signal. An Auto Setup allows you to quickly get the image “in the ballpark”
after which you can perform further calibration, if necessary.
To perform an Auto Setup, do one of the following:
On the Theater Master Remote Control: Press FUNCS, then AUTO followed by
Enter. When the Auto Setup completes, press Enter again to keep the new settings.
On the Projector Rear Keypad: Press AUTO SETUP followed by Enter. When the
Auto Setup completes, press Enter again to keep the new settings.
On the DHD Controller Remote Control: Press MENU, then select Service from the
Main menu. Select Display Device from the Service Menu. Finally, select Configure from
the Display Device menu, then select Auto Setup.
What an “Auto Setup” Does: Auto Setup sets the following parameters to their default
values:
•Contrast
• Brightness
• Auto Input Level (off)
• Detail (if video source)
• Filter
• Luma Delay
Auto Setup also optimizes the following settings, based on the characteristics of the
incoming signal:
• Pixel Tracking
• Pixel Phase
• Size and Blanking
• Vertical Stretch
•Position
• Input Levels
If additional fine-tuning is necessary after performing an Auto Setup, continue with the
next section.
You cannot use Auto Setup with a locked channel. Copy the
locked, factory-default channel for the current input to a new
channel before using Auto Setup; refer to
Copying Channels on
page 46.
Note