Filter
Top Products
U
SING
Y
OUR
P
RINTER
ON
A
N
ETWORK
E.10
6
Press the scroll button ( or ) to display “Yes” and
press the Enter button ( ).
7
Press the Upper Level button ( ), then use the scroll
button ( ).
8
Press the Enter button ( ) when “IP Get Method”
displays.
9
Press the scroll button ( or ) to display “DHCP” and
press the Enter button ( ).
10
To assign the address from the BOOTP server, press the
Enter button ( ) when “BOOTP” displays.
11
Press the ON Line/Continue button ( ) to return to
ready mode.
Configuring IPX Frame Types
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of network communication frames must be specified
on the printer. In most cases, you can keep the default setting
“AUTO”. However, you can manually set the frame type format,
if required.
• AUTO (default): Automatically senses and limits the frame
type to the first one detected.
• EN_8023: Limits the frame type to IPX over IEEE 802.3
frames. All others will be counted and discarded.
• EN_II: Limits the frame type to IPX over Ethernet Frames.
All others will be counted and discarded.
• EN_8022: Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others will be counted and discarded.
• EN_SNAP: Limits the frame type to IPX over SNAP with IEEE
802.3 frames. All others will be counted and discarded.
Note that the IPX/SPX protocol must be enabled in the Netware
menu before you can configure frame types. See “Setting
Network Protocols” on page E.7.