Filter
Top Products
A.7
A
Guidelines for Using Paper
For the best result, use conventional 75 g/m
2
(20 lb) paper. Ensure that the paper is
of good quality, and free of cuts, nicks, tears, spots, loose particles, dust, wrinkles,
voids, and curled or bent edges.
If you are unsure of what type of paper you are loading, such as bond or recycled
paper, check the label on the package.
The following problems may cause print quality deviations, jamming, or even damage
to the machine:
N
OTES
:
• Do not use letterhead paper printed with low-temperature inks, such as those used in
some types of thermography.
• Do not use raised or embossed letterhead.
• The machine uses heat and pressure to fuse toner to the paper. Insure that any
colored paper or preprinted forms use inks that are compatible with this fusing
temperature (189 °C or 372.2 °F for 0.1 second).
Symptom Problem with Paper Solution
Poor print quality or toner
adhesion, problems with
feeding
Too moist, too rough, too
smooth, or embossed;
faulty paper lot
Try another kind of paper,
between 100 ~ 400 Sheffield, 4
~ 5 % moisture content.
Dropout, jamming, curl Stored improperly Store paper flat in its moisture-
proof wrapping.
Increased gray background
shading/machine wear
Too heavy Use lighter paper, use the rear
output slot.
Excessive curl problems
with feeding
Too moist, wrong grain
direction, or short-grain
construction
• Use the rear output slot.
• Use long-grain paper.
Jamming, damage to
machine
Cut-outs or perforations Do not use paper with cutouts
or perforations.
Problems with feeding Ragged edges Use good quality paper.