Filter
Top Products
37
n=2, Type ID
Bit Off/On Hex Decimal Function
0 Off 00 0 Two-byte character code not supported.
1 Off 00 0 Auto cutter not equipped.
2,3 - - - Undefined.
4 Off 00 0 Not used. Fixed to Off.
5,6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.
[Notes]
• When DTR/DSR control is selected, the printer transmits only 1 byte after
confirming that the host is ready to receive data(DSR signal is SPACE).
If the host computer is not ready to receive data (DSR signal is MARK),
the printer waits until the host is ready. When XON/XOFF control is selected,
the printer transmits only 1 byte without confirming the condition of the DSR
signal.
• The printer ID is transmitted when the data in the receiving buffer is developed.
Therefore, there may be a time lag between receiving this command and
transmitting the status, depending on the receive buffer status.
GS V m n
[Name] Feed paper for cutting position.
[Format] ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range] 65 ≤ m ≤ 66, 0 ≤ n ≤ 255
[Description] Feeds paper for cutting position as follows:
m Print mode
65
Feeds paper (cutting position + [n×(vertical motion unit)]), and cuts the
paper Partially.
66
Feeds paper (cutting position + [n×(vertical motion unit)]), and cuts the
paper partially.
GS r n
[Name] Transmit status.
[Format] ASCII GS r n
Hex 1D 72 n
Decimal 29 114 n
[Range] 1 ≤ n ≤ 2, 49 ≤ n ≤ 50
[Description] Transmits the status specified by n as follows.
n Function
1, 49 Transmits paper sensor status.
2, 50 Transmits drawer kick-out connector status.